The NEBNext® Ultra™ II FS DNA Library Prep Kit for Illumina provides a fragmentation system: a fast and reliable solution for DNA fragmentation and library construction. A new DNA fragmentation reagent is combined with end repair and dA-tailing reagents, allowing these steps to be performed in the same tube, with no clean-ups or sample loss. The same fragmentation protocol is used for any input amount (100 pg–500 ng), or GC content. The kit also includes the NEBNext Ultra II Ligation Master Mix for adaptor ligation, and the NEBNext Ultra II Q5® Master Mix for uniform, high-fidelity library amplification. Please note that adaptors and primers are not included in the kit and are available separately.
For protocols including bisulfite converted DNA, we recommend the NEBNext Ultra II DNA Library Prep Kit for Illumina.Features:
Fragmentation, end repair and dA-tailing reagents in a single enzyme mix
A single fragmentation protocol, regardless of DNA input amount or GC content
Input amounts: 100 pg–500 ng
Input DNA can be in water, Tris or TE
Workflow: ~ 2.5 hours, with < 15 minutes hands-on time
Download extensive performance datain our technical note.Also available with optional SPRIselect® beadsfor size selection/clean-up steps
For use with NEBNext Multiplex Oligos for Illumina (Unique Dual Index UMI Adaptors DNA Set 1) (NEB #E7395), refer to the Protocols tab for UMI Adaptors-specific guidance.
Figure 1: NEBNext Ultra II FS DNA produces the highest yields, from a range of input amountsLibraries were prepared from Human NA19240 genomic DNA using the input amounts and numbers of PCR cycles shown. For NEBNext Ultra II FS, a 20-minute fragmentation time was used. For Kapa™HyperPlus libraries, input DNA was cleaned up with 3X beads prior to library construction, as recommended, and a 20-minute fragmentation time was used. Illumina® recommends 50 ng input for Nextera, and not an input range; therefore, only 50 ng was used in this experiment. “Covaris®” libraries were prepared by shearing each input amount in 1X TE Buffer to an insert size of ~200 bp using a Covaris instrument, followed by library construction using the NEBNext Ultra II DNA Library Prep Kit (NEB #E7645). Error bars indicate standard deviation for an average of 3–6 replicates performed by 2 independent users.Figure 2: NEBNext Ultra II FS DNA provides consistent fragmentation regardless of input amountLibraries were prepared from Human NA19240 genomic DNA using the input amounts shown. NEBNext Ultra II FS libraries were prepared using a 20-minute fragmentation time. For Kapa™ HyperPlus, input DNA was cleaned up with 3X beads prior to library construction, as recommended, and a 20-minute fragmentation time. Library size was assessed using the Agilent® Bioanalyzer®. Low input (1 ng and below) libraries were loaded on the Bioanalyzer without a dilution. High input libraries were loaded with a 1:5 dilution in 0.1X TE.Figure 3: NEBNext Ultra II FS DNA provides uniform GC coverage for microbial genomic DNA over a broad range of GC compositionLibraries were prepared using 1 ng of a mix of genomic DNA samples from Haemophilus influenzae, Escherichia coli (K-12 MG1655), Rhodopseudomonas palustris and the library prep kits shown, with 9 PCR cycles for consistency across samples, and sequenced on an Illumina MiSeq®. NEBNext Ultra II FS libraries were prepared using a 20-minute fragmentation time. For Kapa HyperPlus libraries, input DNA was cleaned up with 3X beads prior to library construction, as recommended, followed by a 25-minute fragmentation time. “Covaris” libraries were prepared by shearing 1 ng of DNA in 1X TE Buffer to an insert size of ~200 bp using a Covaris instrument, followed by library construction using the NEBNext Ultra II DNA Library Prep Kit (NEB #E7645). Reads were mapped using Bowtie 2.2.4 and GC coverage information was calculated using Picard’s CollectGCBiasMetrics (v1.117). Expected normalized coverage of 1.0 is indicated by the horizontal grey line, the number of 100 bp regions at each GC% is indicated by the vertical grey bars, and the colored lines represent the normalized coverage for each library.Figure 4: ULTRA II FS produced 10-15x more DNA library compared with other methods -Data from Peter Ellis of the Wellcome Trust Sanger InstituteHuman genomic DNA was subjected to DNA library construction using an existing DNA library construction workflow (CURRENT), NEB Ultra II or NEB Ultra II FS. Adapter-Ligated libraries were amplified by PCR (4-12 cycles), purified and quantitated using the Agilent Bioanalyzer platform. Values obtained were used to normalize DNA library yield from 12 cycles of PCR.
View additional data presented at AGBT by Peter Ellis, Senior Staff Scientist at the Wellcome Trust Sanger Institute.
This product is related to the following categories:
核糖核酸酶A是内切核糖核酸酶,可特异地攻击RNA上嘧啶残基的3'端,切割与相邻核苷酸形成的磷酸二酯键。反应终产物是嘧啶3'磷酸及末端带嘧啶3'磷酸的寡核苷酸。无辅因子及二价阳离子存在时,核糖核酸酶A的作用可被胎盘RNA酶抑制剂(B1ackburn et al.1977)或氧钒—核糖核苷复合物(Puskas et al.1982)所抑制。核糖核酸酶A用途生化研究,测定核酸的结构RNase 保护检测去除非... 查看更多>
DNase I 是一种核酸内切酶,降解双链或单链DNA,产生5-磷酸末端的单核苷酸及寡核苷酸,在Mg2+存在时,DNase I独立地作用每条DNA链,切割位点是随机分布,在Mn2+存在下,DNase I 作用于DNA双链的大致同一位置,产生钝末端或具1-2个核苷酸突起的DNA片段。来源:牛胰贮存条件:4℃应用:1、用切口平移法进行放射性标记时,可用DNase I在双链DNA上产生随机切口;2、在进行亚硫酸氢盐介导的诱变前,可用DNase... 查看更多>