
Test Label: Alkaline PhosphataseTest Format: Double Antibody Sandwich (DAS) ELISACapture Reagent: PolyclonalDetection Reagent: Polyclonal
Intended Use:
The Agdia Bt-Cry3A ELISA was developed for the detection of or the absence of Cry3A protein expressed from NewLeaf® transgenic potato events.Bt endotoxins are proteins produced in plants or in culture expressed by genes taken from the bacterium, Bacillus thuringiensis. Using this test system, you can detect Bt endotoxin extracted from transgenic potato sprouts, tubers and leaves expressing the truncated Cry3A gene.Agdia GMO Trait ELISA"s are commonly used by plant breeders, universities and private testing labs throughout the world.NewLeaf® is a registered trade mark of Monsanto Company.
Includes:
- Antibody-coated 96-well microtiter plates
- Alkaline phosphatase enzyme conjugate
- PNP substrate tablets, 5 mg each
- PNP substrate buffer, 5X concentrate
- Positive control
- Nonfat dried milk
- PBST buffer, 20X concentrated liquid
- Tween-20
- User Guide
ebiomall.com






>
>
>
>
>
>
>
>
>
>
>
>
蛋白质上样缓冲液中的SDS和DTT分别可以屏蔽蛋白质电荷以及破坏二硫键,避免形成多聚体。
DNA上样缓冲液主要是起沉降和指示作用,不可用于蛋白,否则会影响蛋白相对分子量定量。
同样蛋白上样缓冲液中的tris-HCl浓度过高也会使溴酚蓝条带扭曲。
我使用的是1%琼脂糖凝胶,电泳缓冲液为0.5×TBE。
请问各位大虾,在不影响实验结果的前提下,这样的含EB的电泳缓冲液可以反复使用多少次?
谢谢^_^
由弱酸及其盐、弱碱及其盐组成的混合溶液,能在一定程度上抵消、减轻外加强酸或强碱对溶液酸碱度的影响,从而保持溶液的pH值相对稳定。这种溶液称为缓冲溶液。
② 应取pH8.0,这样可使核苷酸带较多负电荷,利于吸附于阴离子交换树脂柱。虽然pH 11.4时核苷酸带有更多的负电荷,但pH过高对分离不利。
③ 当不考虑树脂的非极性吸附时,根据核苷酸负电荷的多少来决定洗脱速度,则洗脱顺序为CMP>AMP> GMP > UMP,但实际上核苷酸和聚苯乙烯阴离子交换树脂之间存在着非极性吸附,嘌呤碱基的非极性吸附是嘧啶碱基的3倍。静电吸附与非极性吸附共同作用的结果使洗脱顺序为:CMP> AMP > UMP >GMP。
1、根据所需求的酸碱性选择合适的缓冲对,若是配制酸性缓冲液就选择弱酸与弱酸盐缓冲对;若是配制碱性缓冲液就选择弱碱与弱碱盐缓冲对。
2、根据所需要控制的PH范围以及弱酸和弱碱的解离常数(pKa/pKb)选择具体的共轭酸碱对,公式为PH=pKa±1=(14-pKb)±1。
3、根据公式计算缓冲溶液的组分比,酸性缓冲液PH=pKa-lgc酸/c盐,碱性缓冲液PH=14-pKb+lgc碱/c盐。
4、根据共轭酸碱对以及其组分比配制缓冲液,方法同普通溶液。
举例:试配制一种缓冲液,体积为1L,PH能维持在10.25左右。
a、依题意选择弱碱与弱碱盐的共轭对;
b、由PH=(14-pKb)±1,算出pKb在3.75与4.75之间,查弱碱的解离常数表可知氨水(pKb=4.75)符合要求,故可选择NH3-NH4Cl体系;
c、由PH=14-pKb+lgc碱/c盐,算出c(氨水)/c(氯化铵)=10;
d、设氨水的浓度为10mol/L,则氯化铵的浓度为1mol/L,所以在浓度为10mol/L体积为1L的氨水中加入1mol的氯化铵即可。

